#Darkstar one mod download

I found the most accurate cut to be achieved when holding the blade angled in a bit toward the material side, and holding some pressure against the target. With one flat side at the lower end, and the rest cut oversized, apply the material one target at a time, cutting around the edge with an exacto knife to be a perfect fit-this is larger and better looking than the smaller factory size. I used a sliding cutter for most straight cuts.similar to this: link »įor the drops: I removed the drop asssembly from underneath and removed the old decals (cleaned any remaining adhesive with 91% alcohol). All sides could be done that way, but I chose to use an exacto knife at the top. It was best to cut the bottom, left, and right sides to proper size beforehand. After pulling the one side, with it on a flat surface, line up the screen materials and carefully apply it flat (I held the other end taught and something like a credit card to slowly push the material down into place to avoid air bubbles).įor the main panel: I placed the material over the factory white panels. When the material is received with the proper direction being the slimmest, you'll likely need to carefully remove the adhesive to get enough height for the main screen panel (the front can be rolled off, but the back may need some help with contact cleaner-alcohol will ruin the material, and goo gone was messy).īefore cuts are made to the screen material, cut enough double sided tape sheet to cover an entire sample. So no matter how tall or short you are, the game will look stellar from player perspective.

When turned the proper way, the image will be perfectly viewable at all 180 degrees from the bottom to the top, but standing further than at the corner of the game left to right will start to show the ambient light rejecting feature this material has. You'll have to figure out which direction is appropriate (they're not guaranteed to be one way or the other on the sheet as I received them both ways).

#Darkstar one mod download

I also pulled the LED near the shooter lane exit and it was one of the worst offenders.Ĭan download the parts and see instructions for the billboard and bulb cones here: Also, the back half of my right flasher is blocked with a piece of black vinyl, the lighting is dimmed in the game through settings, and I made partial cones to go over the sling LEDs (still some room to better darken this area from the screen, which perhaps I'll do later). To achieve the results seen in the installed video, I also have 1-3 layers of cardstock in all of the large arrow inserts and some of the smaller inserts closer to the screen. This is the adhesive sheeting I used (I also ordered the more expensive 3M sheets, but found this cheaper option to be the easiest to work with): link » I purchased the screen material here, and would recommend having 5 sample sheets (it's possible this will prove to be difficult):